Shovelhead Starter Solenoid Problems
Shovelhead Starter Solenoid Problems. 1980 cb900 1979 flh shovelhead. Where the relay wire is connected, but you still have trouble starting,.
85 to ground,87 to solenoid,86 gets wire fr. The torque on the starter shaft prevents the bendix from disengaging the starter ring gear and , physically, holds the solenoid contacts closed by the mechanical linkage. Starter spins without fully engaging the.
Where The Relay Wire Is Connected, But You Still Have Trouble Starting,.
I think the starter or rather the wiring of the starter / starter relay is the problem. No clicking noise when trying to start the engine 1.3. This part came off a 1982 flh.full video inc.
Easiest Way Is To Get The New Solenoid Assembly, But Most Just Reverse The Washer (Contact) And Burnish The Contacts.there Will Be A Time When You Need To Replace The.
Ive been running the lever solenoid for close to 2 years now. How to test a harley davidson shovelhead starter solenoid and how to rebuild the solenoid using the old parts. Used a 40 amp bosch relay.
The Only Way I Can Get It To Stop, Is.
The starter housing, the one with the big gear in it is. I have seen this issue many times over the years, starter solenoid does not release when starter switch is released and cranks til something burns up, most times battery is shot. Used a ground strap from starter to tranny.
Have Removed Inspected Cleaned And.
I like it, has been trouble free so far.bit of a pain to set up but ive not touched it since i put it on. This bike was n!#%$#@r rigged from the word. You can clean them up on a wire brush.
For Your Shovelhead To Start Correctly, The Starter Relay Wire Must Be Connected To The S Part Of The Solenoid.
This bike is running a sealed. Check to see if there',s 12.8 volts at the small (green) wire on the solenoid when ya push the start button. When i push the starter button.
Post a Comment for "Shovelhead Starter Solenoid Problems"